mjsargent1010
New Member
- Messages
- 1
- Location
- Jackson Mi
I have an old OTC Daihen Almega series robot set up to weld aluminum parts. The issue I’ve been having is that the robot with stop mid weld and start up again about 2-4 mm away from were it stopped leaving a little wire nub on the weld where it stopped. To my knowledge my ground is fine and setup under a turntable. Could my issue be erratic wire feeding or is it my parameters or wire feed settings and voltage? I have a miller auto axcess wire feeder helping the wire through and it’s on the accu-curve settings. Any thoughts?