pressbrake1
Forum Supporter
- Messages
- 5,282
NoIs it a SH125?
NoIs it a SH125?
Don't tell them that, they'll assume it's commercial.Commercial activity is closed, it’s for my personal stuff
Are you still involved with such unpleasantness madam?Could put that on a 3 axle special types step frame, that would be fine. It would put me into STGO cat 2 just about on a 3 axle step. That would be the smallest set up for moving it on though.
Unfortunately haha.Are you still involved with such unpleasantness madam?
Will only lift just over 10 ton, even a Mil 26 ( largest helicopter) only lifts 20 ton.Chinnok!
Messed up my conversion somewhere.Will only lift just over 10 ton, even a Mil 26 ( largest helicopter) only lifts 20 ton.
Cranes, less than £100 an hour.
If the road was wide enough I’d put it on axles and drag it home with a d8!How are you going to move that across the lawn into your workshop???
Take the roof off and crane it in...
Minimum cost for contract lift is £800 plusCranes, less than £100 an hour.
Really? different over here.Minimum cost for contract lift is £800 plus
The £800 was to lift a pressbrake when crane depot was next door!Struggle to get a contract lift for under 1100 up here! But that's with RAMS etc for insurance purposes.
If there's no major roads or motorways I'd be tempted to get someone to move that at night as already mentioned
A low loader for a 30t excavator, would that not fit the bill for moving it?
you haven’t seen the lane to Clive’s house...
If you use a D8 you could have 2 way traffic and grade the track at the same time ...If the road was wide enough I’d put it on axles and drag it home with a d8!