Reversing an ac motor.

[8ob]

Reverse on a lathe does have its uses, right hand tooling upside down in reverse doing the same job as left hand tooling for one.

Bob

 

[badabec]

I use an Eccentric Engineering parting tool in my lathe. You run the lathe in reverse. The chips fall out rather than building up. My Boxford has a D3 chuck mount.

 

[Seadog]

I use an Eccentric Engineering parting tool in my lathe. You run the lathe in reverse. The chips fall out rather than building up. My Boxford has a D3 chuck mount.

A D3? How is it attached to the spindle?

 

[badabec]

Sorry I meant D1-3. Three cams in the nose piece tighten on the waisted area of the pins.
Picture is from ebay, best image I could find.

 

[oldbikedavey]

Well, the reversing switch has arrived....
Circling it all rather warily.......