Reasonable Fillet Weld?

[Buggerlugs]

So I did a fillet weld on a small piece of 4mn thick, mild steel. I had discovered that I was previously going a bit fast and was getting slag inclusion.

After slowing down, it made for better looking welds.

All done on a Parkside PIFDS 120 B2 inverter flux cored welder @ 120 Amps, with 0.9mm flux cored wire.

On the second image, I had a moment of extreme heat on the back of my glove, so I had to stop, briefly.

 

[Mark 2]

That'll do, not quite sure how you would get slag inclusion with flux core but hey ho.
Lidl wire?

 

[Buggerlugs]

That'll do, not quite sure how you would get slag inclusion with flux core but hey ho.
Lidl wire?

Not Lidl wire, but from Oxford Welding Supplies. I think I meant weld porosity, not slag inclusion.

 

[marlinspike]

I'd be very happy with that if the other side looked ok.