Race transporter

[Mick Annick]

This is closer

Porte bagages,Sales Porte bagages De gros

Pas cher Rabais Porte bagages Fournisseur,Low Prices Porte bagages Promotions,Supply Porte bagages Achats,Haute qualité Porte bagages Fabricant Usine!

fr.tepkos-autoparts.com

 

[GSR]

W

What do you race and where?

I’ve got a civic type r that I race - picture further up in this thread showing the lift working. The series I race in is relatively southern based - brands hatch, Lydden, snetterton, castle Combe, silverstone and Mallory park.

 

[GSR]

Not got around to sorting the locker doors yet, but need 2 cars to the next meeting so have had to get the twin deck in. It’s physically in but not fixed or plumbed yet.

Plan to get it fixed in properly this weekend - any suggestions for the grade of hydraulic oil I need?

Thanks

 

[GSR]

Any 24v hydraulic experts reading? It appears I didn’t get the control box or buttons when picking the body up. Put power direct to the pump and it works, but no idea when it comes to the power in and power out solenoids for lifting and lowering the deck? The inner most terminal is an earth but not sure where power needs to go to on the others - have tried both but nothing clicked or happened

Other than the hydraulics not working, which I don’t need until end of September it’s in and up high enough with the safety bars so that can I still get 1 car in and use it as it is

 

[GSR]

So it turns out I didn’t get the rams in the right place, they are too close to horizontal when in the lowered position so I can’t lift it on the rams.

So to get it useable for 2 cars for last weekend I had to improvise.

A little bit of messing about but it works, am thinking I’ll replace the block and tackle with an electric winch as a permanent solution.

 

[GSR]

Progress is slow, but progress

But trying to crack on and get the lockers sorted before the start of this race season so it’s a bit more organised
I’ve been waiting all week for piano hinges to arrive for the doors between the axles , turns out I hadn’t completed the order when I looked for the order confirmation email to chase them up! On temporarily for now, will replace with piano hinge when it arrives

 

[qwakers]

side skirts and lockers have been on my list for a while. the way you are going about it is new to me and appeals greatly. where did you get the doors? or did you make them?

 

[GSR]

There’s so much space there that otherwise wouldn’t be used. I built them the same on my last lorry but as it was a 7.5ton the doors were shorter so had them hinged at the bottom to drop down, these would be too big to reach over so had to hinge up.
Doors are just 1mm sheet bent on a mates box pan folder. Frame is all 40x40 angle and will use 12mm or 18mm for the base and sides