powderblast
Member
- Messages
- 706
- Location
- Hull, UK
Hi all i upgraded my welder from the 180 to the 250mig i mainly use it for 0.8 wire but i thought i would buy some 1mm wire just to run it at full power i have noticed though that you cannot have the wire feed set on max as it will just kickback the torch is this normal for these 250s as on the 0.8wire i can run both knobs on full just unsure if this is correct running 1mm wire or if there is an issue?
Any you guys who have the same machine have the same issue?
Any you guys who have the same machine have the same issue?