pondy
Member
- Messages
- 1,627
- Location
- chedburgh, suffolk. uk
Evening all
Owned the above since August this year but can't get on with it. I moved from a cheap cut 40 as an upgrade, I prefer my old unit.
It seems to have no consistency in cut quality, most evident issue is it likes to cut at angles, lots of slag etc. I've had some very nice cuts out of it but that's rarely. Its got a decent air supply. I dont think it's my technique, doing the same thing as when I do decent cuts, I use oxy cutting and a large lincoln plasma at work with zero issues. Stats claim 8mm clean. 12mm severance. This is 10mm which I've cut cleanly before. Lower plate is tonight's efforts. Thick plate holding it down was done with oxy acetylene today at work
Sam
Owned the above since August this year but can't get on with it. I moved from a cheap cut 40 as an upgrade, I prefer my old unit.
It seems to have no consistency in cut quality, most evident issue is it likes to cut at angles, lots of slag etc. I've had some very nice cuts out of it but that's rarely. Its got a decent air supply. I dont think it's my technique, doing the same thing as when I do decent cuts, I use oxy cutting and a large lincoln plasma at work with zero issues. Stats claim 8mm clean. 12mm severance. This is 10mm which I've cut cleanly before. Lower plate is tonight's efforts. Thick plate holding it down was done with oxy acetylene today at work
Sam