- Messages
- 21,567
- Location
- Birmingham
Well at least it wasn't the welders fault this time went to look at an overheating tig torch and ended up with a major job.
Due to trying to maximise floor usage the engineers decided to build a triple weld bay against the back of an existing machine guard. then thought it would be good to put the weldsets behind the bay leaving a gap at one end for service etc.
Of course it would be the last set I needed to work on, so had to disconnect all 3 sets and pull them and their bottles out through the gap, Murex didn't help by hardwiring the cooler in
A 5 minute job took over an hour!
Due to trying to maximise floor usage the engineers decided to build a triple weld bay against the back of an existing machine guard. then thought it would be good to put the weldsets behind the bay leaving a gap at one end for service etc.
Of course it would be the last set I needed to work on, so had to disconnect all 3 sets and pull them and their bottles out through the gap, Murex didn't help by hardwiring the cooler in
A 5 minute job took over an hour!