B bob jones New Member Messages 2 Jul 18, 2011 #1 just noticed that gas continues to flow after the ten seconds set on the timer. Stops when i shut the welder down.
just noticed that gas continues to flow after the ten seconds set on the timer. Stops when i shut the welder down.
shenion Tool Pack Rat Messages 7,586 Location Stone Mountain, GA USA Jul 18, 2011 #2 you are using a remote footpedal or switch? If so, then looks like it could be the TD1 relay sticking.
you are using a remote footpedal or switch? If so, then looks like it could be the TD1 relay sticking.
B bob jones New Member Messages 2 Jul 19, 2011 #3 td1 relay thanks for the possible answer. i am using a foot pedal and where is the TD1 relay located.
td1 relay thanks for the possible answer. i am using a foot pedal and where is the TD1 relay located.
