Malcolm Begg
New Member
- Messages
- 16
- Location
- Caithness
Hi
I have just received this welder with a stuck switch, I managed to get the switch sorted but when I put it together I was not sure if I got the cams in the right rotation, when you take these apart the bits go everywhere ,it is a 6 position Kende switch 0-6, 4 bank.Does anyone out there know the consequences of switching this on if the cams are in the wrong sequence,
or does anyone know how to check the switch positions and what readings I should expect for each position.
Thanks
Malcolm
I have just received this welder with a stuck switch, I managed to get the switch sorted but when I put it together I was not sure if I got the cams in the right rotation, when you take these apart the bits go everywhere ,it is a 6 position Kende switch 0-6, 4 bank.Does anyone out there know the consequences of switching this on if the cams are in the wrong sequence,
or does anyone know how to check the switch positions and what readings I should expect for each position.
Thanks
Malcolm