scottonthefen
New Member
- Messages
- 22
- Location
- England
I finally sparked up my portamig today and had a play welding some scrap up and experimenting with the settings.
I found some settings that worked well enough for the 2mm steel I was playing with. It wasn't burning through and the other side looked well scorched so the penetration seemed ok.
My instructions say I have 12 voltage settings. 1-6 on the left (fine), then turn the right (coarse) to 2 and go up through the fine numbers again on the left (7,8,..,12).
But.. what are the OTHER 1 and 2 on the coarse dial at the 6 and 9 o-clock positions?
Cheers!
I found some settings that worked well enough for the 2mm steel I was playing with. It wasn't burning through and the other side looked well scorched so the penetration seemed ok.
My instructions say I have 12 voltage settings. 1-6 on the left (fine), then turn the right (coarse) to 2 and go up through the fine numbers again on the left (7,8,..,12).
But.. what are the OTHER 1 and 2 on the coarse dial at the 6 and 9 o-clock positions?
Cheers!