pondy
Member
- Messages
- 1,627
- Location
- chedburgh, suffolk. uk
Got my 185 from steve friday and took it out the box and tested it today, it seems to be lacking power. Its my understanding that course 2 and fine is max power? Been running some beads on 3mm thick box and some times will blow a hole but mist times does not penetrate, just glows red on underside. Found you can weld with wire speed on 0, I was using it at 1.5.
I have a 16a plug fitted as have a supply at home but using at work so have a 16a to 13a convertor, does not blow fuse on what I think is full power? Was told it will blow over 150a?
Im using pub c02, tried 10 to 20lpm. Welds are clean but get alot of splatter build up in shroud?
Understand about having on course 1 and working through the fine till 6, then going to course 2 then fine 1 to 6 (max). There is 2x1 and 2x2 on the course, are they the same?
I have emailed steve about this, am I doing anything wrong?
I have a 16a plug fitted as have a supply at home but using at work so have a 16a to 13a convertor, does not blow fuse on what I think is full power? Was told it will blow over 150a?
Im using pub c02, tried 10 to 20lpm. Welds are clean but get alot of splatter build up in shroud?
Understand about having on course 1 and working through the fine till 6, then going to course 2 then fine 1 to 6 (max). There is 2x1 and 2x2 on the course, are they the same?
I have emailed steve about this, am I doing anything wrong?