Plumbing question - thermal store pipes

[Kayos]

Keep it simple. Unsolder the pipe from the tmv fittings and reuse those and use female bsp to copper on the plate, just double check they are bsp first

 

[maz0]

I’m still trying to figure out what your trying to accomplish

 

[julianf]

Keep it simple. Unsolder the pipe from the tmv fittings and reuse those and use female bsp to copper on the plate, just double check they are bsp first

The one in my photo is just another unit i found here - its not the actual one off the store.

It looks like the one on the store is all brazed pipe - that i cant just unsolder it.

The actual pipe going through the wall of the store is 22mm, but im not sure i have the confidence to saw the flanged end off it...

 

[julianf]

This is a photo of the joint on the actual store, where it goes from 22mm up to the flanged bit -

Does not look soldered.

 

[julianf]

I’m still trying to figure out what your trying to accomplish

Our hot water here gets heated by solid fuel or solar.
I'm 'simply' trying to boost its temp, when needed, using an oil fired boiler.

: )