chunkolini
celebrity artiste
- Messages
- 9,337
- Location
- Swansea
I have a 2m length of ERW tubing to cut in half, I think about 60mm diameter and around 2mm wall.
Just to be awkward I have to cut it in half lengthwise as I need two half tubes.
Angle grinder and slitting disc using a guide or plasma cutter using a guide?
I actually need lots of shortish pieces but think it might be best to do it in one go first.
What do you chaps think?
Just to be awkward I have to cut it in half lengthwise as I need two half tubes.
Angle grinder and slitting disc using a guide or plasma cutter using a guide?
I actually need lots of shortish pieces but think it might be best to do it in one go first.
What do you chaps think?