Is a slop simerla to a Slope?
2t and 4t are torch latching modes, same as mig. 2t is touch torch on switch and hold down, once you let go the welding process stops, ideal for short welding runs. 4t mode touch torch switch to start welding and let go then touch switch again to stop.
The way my ifl unit is normally set up is 4t mode, with finishing current set to about 60amps (depends what im doing) on the switch off torch mode as long as i have my finger on the switch it wont switch off until i let go, i use the 60amp for crater filling, works well without a foot pedle
has your boiler gone too(he he)I've suddenly gone cold!
go on how much you pay for it
has your boiler gone too(he he)
Hey weldequip, its just for the unit i was asking about the regulator and hose for,
thanks