Noods
Member
- Messages
- 979
- Location
- Ipswich
Hi
I’ve a Parweld AC/DC Tig setup XTT202 with a Parweld pedal also..
My Question is..
When the torch is directly plugged into the welder directly I can easily set and adjust the amps as req..
But when I use the pedal ( I know it’s got a red knob on the side to adj travel ) I can’t seem to adjust the maximum amount of amps I intend to use, this would be handy to me, so anyone any ideas.. ?
hopefully it’s just something I’ve missed ..
Thank you
I’ve a Parweld AC/DC Tig setup XTT202 with a Parweld pedal also..
My Question is..
When the torch is directly plugged into the welder directly I can easily set and adjust the amps as req..
But when I use the pedal ( I know it’s got a red knob on the side to adj travel ) I can’t seem to adjust the maximum amount of amps I intend to use, this would be handy to me, so anyone any ideas.. ?
hopefully it’s just something I’ve missed ..
Thank you
Last edited: