Parts needed for hose adaptor

[marknotgeorge]

What bits are needed for a hose to connect my Sip Cosmo welder to a big gas bottle regulator? From the ones I've seen on eBay and elsewhere, it looks like not much more than a bit of garden hose, some connectors and a couple of jubilee clips.

 

[malcolm]

That should be all that's needed. If you've got a nice new regulator and a bit of plastic hose sticking oiut of the back of the mig then alal that's needed is a bit of hose to join the two together.

The pressure is quite high, so the bit of hose needs to overlap the hose on the welder for a couple of inches, and you'll need a jubilee clip to stop it blowing off.

 

[weldequip]

What bits are needed for a hose to connect my Sip Cosmo welder to a big gas bottle regulator? From the ones I've seen on eBay and elsewhere, it looks like not much more than a bit of garden hose, some connectors and a couple of jubilee clips.

A bit more to it than that! There is a special reducer fitting to 'step-up' the small white plastic pipe on the back of your MIG to an industrial bore hose.
I have them in stock & can supply just the reducer or the complete conversion kit.
weldequip