https://www.lidl.ie/p/plasma-cutter-with-compressor/p10019305 (£85)
Vs
https://www.amazon.co.uk/YESWELDER-Non-Pilot-Cutting-Inverter-Thickness/dp/B09DY7S13H (£133 + investing in compressor which could then have other uses of course)
I know very little about these but see that the Parkside option comes with compressor built in, while the Yeswelder would require a separate compressor set up alongside.
Would welcome any opinions on whether one of the two machines is significantly better than the other, or if one of them just represents much better value starting out
Any helpful pointers here much appreciated. Thanks
Vs
https://www.amazon.co.uk/YESWELDER-Non-Pilot-Cutting-Inverter-Thickness/dp/B09DY7S13H (£133 + investing in compressor which could then have other uses of course)
I know very little about these but see that the Parkside option comes with compressor built in, while the Yeswelder would require a separate compressor set up alongside.
Would welcome any opinions on whether one of the two machines is significantly better than the other, or if one of them just represents much better value starting out
Any helpful pointers here much appreciated. Thanks