Vixerfixer123
Member
- Messages
- 59
- Location
- West midlands
Morning folks.need some ideas for building some kind of extraction for my garage,maybe fans built into a box with a filter,as I don’t want to be drilling holes in the garage.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an alternative browser.
You should upgrade or use an alternative browser.
Paint extraction ideas
- Thread starter Vixerfixer123
- Start date
Wildefalcon
Member
- Messages
- 2,569
- Location
- Gloucestershire, England
Fit an inner door with the holes to extract.
Vixerfixer123
Member
- Messages
- 59
- Location
- West midlands
Space is also quite limited aswell though.garage is only 7x4mFit an inner door with the holes to extract.
Vixerfixer123
Member
- Messages
- 59
- Location
- West midlands
Wonder if I could make an inner door over the normal side entry door rather than the roller shutter.would a fan top & bottom work,one pulling air in and the other to extract,but would need to extract it into a filter,as I don’t want neighbours moaning about any smells.
What you do with a side entry door is
Pop to B&Q and get some roofing lath
Make a proper jointed frame with it to fit snuggly into the non opening side of the door frame and also carry the fan (you need a big one) Block the rest of the frame with hardboard or whatever you have. Put a couple of B&Q steel desk drawer type handles on the fan mount so you can shift it around.
Obviously the fan is run with the actual door wide open.
Pop to B&Q and get some roofing lath
Make a proper jointed frame with it to fit snuggly into the non opening side of the door frame and also carry the fan (you need a big one) Block the rest of the frame with hardboard or whatever you have. Put a couple of B&Q steel desk drawer type handles on the fan mount so you can shift it around.
Obviously the fan is run with the actual door wide open.
