Evening all, first post on here and it's probably in the wrong section, and isn't really about welding
I bought and set up a oxy-propane torch today, I've used an oxy-acetylene before, but never oxy-propane or set one up.
I have a pepper pot on the end for heating metal, however the thing is just blowing back the whole time and making some rediculous noises, I have no idea if the pressure it too high, low or what. After playing around for a while the pepper pot was a bit melted
Perhaps it's a lot easier with a cutting bit and pepper pots need loads of pressure??
Anyhow I'm a bit lost as to what I should do from here, what should I try?
Don't suppose there is any memebers near Bristol who wouldn't mind popping over, having a look and giving me some tips in exchange for some lovely beer??
Cheers
I bought and set up a oxy-propane torch today, I've used an oxy-acetylene before, but never oxy-propane or set one up.
I have a pepper pot on the end for heating metal, however the thing is just blowing back the whole time and making some rediculous noises, I have no idea if the pressure it too high, low or what. After playing around for a while the pepper pot was a bit melted
Perhaps it's a lot easier with a cutting bit and pepper pots need loads of pressure??
Anyhow I'm a bit lost as to what I should do from here, what should I try?
Don't suppose there is any memebers near Bristol who wouldn't mind popping over, having a look and giving me some tips in exchange for some lovely beer??
Cheers