- Thread starter Farm789
- Start date
oilcooled :)
Pipe Welder, Mechanical engineer
- Messages
- 997
- Location
- Ireland
I rang tec arc and bought this
There’s a small wire you clip on to what your welding for the wire feeder to work, I got them to run that back in the snake lead and I connected that to the earth in side in the welder machine. I had awful bother with porosity with it , it was drawing air, up threw the Euro torch on the welder where the welding wire should be present but isn’t cause your not using that wire feeder anymore, I just had to block that hole and it’s been flawless since
CFeed 300 Universal add on wire feeder to fit any MIG
CFeed 300 with 5M interconnector £490. CFEED 300 with 10M interconnector £550. Discounts for approved distributors, volume & export. Upgrade compact MIG’s to separate wire feed in seconds…
technicalarc.co.uk
There’s a small wire you clip on to what your welding for the wire feeder to work, I got them to run that back in the snake lead and I connected that to the earth in side in the welder machine. I had awful bother with porosity with it , it was drawing air, up threw the Euro torch on the welder where the welding wire should be present but isn’t cause your not using that wire feeder anymore, I just had to block that hole and it’s been flawless since
oilcooled :)
Pipe Welder, Mechanical engineer
- Messages
- 997
- Location
- Ireland
The one I sent you Is for the older type mig makers it plugs into the euro torch connection on the welder, best bet is ring them and talk to Les Ford
