In theory, what tool could I use if I need to cut a washer, from the thin side (i.e. 1mm-2mm wide) in half?
To make things even harder, I only have about 3cm clearance above it.
Time is not an issue.
I was thinking either this:
http://www.diy.com/nav/fix/handtool...s/saws/hacksaws/B-and-Q-Mini-Hacksaw-11247852
or
a reciprocating saw, although that might be a bit brutal.
To make things even harder, I only have about 3cm clearance above it.
Time is not an issue.
I was thinking either this:
http://www.diy.com/nav/fix/handtool...s/saws/hacksaws/B-and-Q-Mini-Hacksaw-11247852
or
a reciprocating saw, although that might be a bit brutal.