Non return valves

[TR5 man]

Can anyone help with finding a compressor non return valve for my, quite old, Clarke 15/60 compressor. I need to fit a replacement but can't find one with the correct fittings. What I need is 1/2 inch male inlet to tank, and 1/2 inch male connection to the air pipe, with a female 10mm switch connector for a 8mm pipe and olive.
But the 1/2 inch pipe connector has to be a female cone, and I can only find ones with a male cone fitting. So frustrating, I would appreciate any information.
Thanks. Dave.

 

[JOEPRO]

Photos of the original valve required would help too if those could be posted


@bourbon do you have any parts listing for this?

 

[Smallfry]

I take it you have tried Clarke themselves ?

 

[timgunn1962]

Maybe a daft question, but why do you need a new one? I've probably changed hundreds of pastels and a good few springs over the years, but I don't recall having to change the brass bits unless I've needed to do so to accommodate some other change to the pipework.

 

[timgunn1962]

I've also found that a lot of the threads for the tube to the unloader on the pressure switch are 1/8" BSP and it's often possible to repipe in 6mm nylon.

 

[bourbon]

Thanks for the heads up, Sorry, only just noticed the thread. That is indeed an older compressor. Phone our tech department on 0871 410 1260. One of those guys will be able to tell you if the design has changed on the more modern ones