shane dolan
New Member
- Messages
- 1
- Location
- wakefield
Please could I have some advice to set up this machine.
What basic settings should I run for this machine. Nexus nxt 200 with argon gas
Sheet steel and box section, angle and tube, all no more than 3mm wall thick
Aluminium flat bar, box section, angle and tube ,all no more than 3mm wall thick.
We normally use and teach MIG (the basics) to our students (16 -18)who need it for their projects however we want to be able to give them the chance to use TIG if their design needs it especially aluminium.
We have machine setup and running, but would appreciate any help and advice.
We would love to have someone come in and train us but due to social distancing, financing restraints and child protection issues this is not possible, therefore back to trail and error.
Kindest regards in advance
What basic settings should I run for this machine. Nexus nxt 200 with argon gas
Sheet steel and box section, angle and tube, all no more than 3mm wall thick
Aluminium flat bar, box section, angle and tube ,all no more than 3mm wall thick.
We normally use and teach MIG (the basics) to our students (16 -18)who need it for their projects however we want to be able to give them the chance to use TIG if their design needs it especially aluminium.
We have machine setup and running, but would appreciate any help and advice.
We would love to have someone come in and train us but due to social distancing, financing restraints and child protection issues this is not possible, therefore back to trail and error.
Kindest regards in advance