brightspark
Member
- Messages
- 39,320
- Location
- yarm stockton on tees
Lots to chose from...
its a minefieldLots to chose from...
Glanze is not your usual import stuff it is almost industrial quality and made with proper steel rather than chewing gum.That is very overpriced for import quality.. The cheapest ebay holders will do everything you need and cost 3-6 quid each delivered. Much better to get cheap holders and good inserts.
I do 90% of my turning with a ccmt 0903 boring bar. It is too big for most boring, small holes Ive got a couple of hss tools.
Oh and that just reminded me, I do use HSS still I use small boring bars/internal grooving tools from WNT and some are solid carbide but others are HSS, they are the dogs danglers for the small stuff
https://www.wnt.com/mastertool/product/Cutting Tools/Turning/Miniature turning tools/UltraMini/UltraMini - Sets/SET 'TURNING-6 GROOVING AND CHAMFERING' ULTRAMINI-9SET NO-91 73085999
If I am looking at the right thing, that would buy a lot of hss.
I will have to keep my eyes open, do they email offers once you start ordering regularly like MSC do.
Those look like carbide.. have a couple very small ones but they have a triangle shank.. too lazy to make a holder for.
Thanks for the kind offer. Pm sent.I have a few tct tipped tools that are too small for my machine, they came in a big set, no use to me. If you like, pm me your address and Ill send them to you, when I get home from work later in the week.
This set... (picture removed)