Got a new Clarke 151EN.
I'm trying to learn but the wire feed just doesn't seem right. It goes in "bursts", pushing out a bit, stopping, pushing out a bit.
I tried adjusting everything but with the slightest resistance it seems to do this on any tension level. Even if I leave the tensioner off and push down with my hand to manually apply tension, it still feels uneven like the roller isn't concentric or something.
Short video:
This is the second reel of wire, it was doing the exact same on the first one (smaller) that came with the welder so I tried this one.
I'm trying to learn but the wire feed just doesn't seem right. It goes in "bursts", pushing out a bit, stopping, pushing out a bit.
I tried adjusting everything but with the slightest resistance it seems to do this on any tension level. Even if I leave the tensioner off and push down with my hand to manually apply tension, it still feels uneven like the roller isn't concentric or something.
Short video:
This is the second reel of wire, it was doing the exact same on the first one (smaller) that came with the welder so I tried this one.