Hello
Currently modifying a Motorcycle rear subframe and I need to Tack the ally so I can get someone to weld it.
Maybe if all goes well I can weld myself
Question is which wire should I go for. Is there only two main types 4043 and 5356??
Have I got a good chance of welding this if I get these two types.
Going for 1mm wire so I take it I should use a 1.2mm tip.
I've seen tips to change the liner next to the rollers for a plastic/Teflon stop it sticking and pull it out as close to the rollers as possible.
Looking around the spare shops and can't seem to fin the bits I need to replace. Or is it the whole liner??
I have a Sealey Mighty MIG 130.
Any suggestions and advice is really appreciated.
I have the argon by the way
Currently modifying a Motorcycle rear subframe and I need to Tack the ally so I can get someone to weld it.
Maybe if all goes well I can weld myself
Question is which wire should I go for. Is there only two main types 4043 and 5356??
Have I got a good chance of welding this if I get these two types.
Going for 1mm wire so I take it I should use a 1.2mm tip.
I've seen tips to change the liner next to the rollers for a plastic/Teflon stop it sticking and pull it out as close to the rollers as possible.
Looking around the spare shops and can't seem to fin the bits I need to replace. Or is it the whole liner??
I have a Sealey Mighty MIG 130.
Any suggestions and advice is really appreciated.
I have the argon by the way