Need a small brass part making, anyone do it for beer tokens?

[DanielW]

That makes no sense, how can a 15mm od pipe have a 13mm wall thickness? The walls would overlap by 11mm.

This is true so maybe I should have said its a 13mm inside diameter. I'm guessing others will have realised this mistake though.

I only paid for a 2 minute argument.

 

[chunkolini]

I would have used filler and or araldite.

 

[MattH]

This is true so maybe I should have said its a 13mm inside diameter. I'm guessing others will have realised this mistake though.

I only paid for a 2 minute argument.

Going to struggle to tap that M8.

 

[Richard.]

Going to struggle to tap that M8.

Send it to me 1st and I'll weld up the hole and send it back.

 

[Wedg1e]

Send it to me 1st and I'll weld up the hole and send it back.

You'll have to wait until I melt down all my brass swarf and cast a new length of rod... well, when I say me I mean Doubleboost, I'd struggle to melt ice cream.

 

[MattH]

 

[CRB]

Free chamfering service too.

 

[ukracer]

View attachment 73103

Strangely enough even I am capable of doing that....lol

 

[Kayos]

The chamfers were added after a PM discussion

They look spot on, and mean I need to pull my finger out soldering the new probes to xlr plugs

 

[MattH]

Sorry, those fail QA, the chamfers are different depths and weren't in the original specification.

Chamfers are identicle on both parts. It's just that each end of the part has a different chamfer. One end to aid insertion and the other to break the edge.

 

[MattH]

I was going to mention that the lead-in on the left hand one's thread looked 'off' too...

Now I realise you cheated and put them different directions

Everyone's a critic!

 

[Wedg1e]

Sorry, those fail QA, the chamfers are different depths and weren't in the original specification.

Never mind that, the surface roughness is no better than Ra0.06

 

[DanielW]

Everyone's a critic!

they're and not a bad job but ya could have made them a bit more prettier ie knurled them for gripping so's he can screw in what he's screwing in.

 

[Pete.]

I don't like the colour but other than that they're ok I guess.....

 

[CRB]

?Depth of thread?

?Was the through hole supposed to be 6.8mm?

So many questions.

 

[Kayos]

Big thanks to @MattH they turned up today and are spot on

Just digging out a few bits and i will have one fitted and in use this weekend

 

[Kayos]

A quick shot of it in use

Connected to my temp controller

Which is warming chemicals to develop some colour film

(I am aware of the irony of taking a picture of something designed to let me make high quality pictures with an iPhone)