- Thread starter sardine
- Start date
Kram
Member
- Messages
- 8,527
- Location
- Sussex
See what temp they melt at - a temp controlled furnace would be best slowely inch up until it melts.
The good silver rods melt below 650-700c.
Or take to a scrappy, who has an xray gun. Or someone with a SEM..
They look a bit corroded to be silver types, also 450mm is short - brazing rods are normally 600mm lengths.
The good silver rods melt below 650-700c.
Or take to a scrappy, who has an xray gun. Or someone with a SEM..
They look a bit corroded to be silver types, also 450mm is short - brazing rods are normally 600mm lengths.
hotponyshoes
Member
- Messages
- 7,947
- Location
- Somerset. Uk
The flat side and the 450mm length would suggest aluminium to me.
Easy way to check that is to weigh them..
Easy way to check that is to weigh them..
