Smashy
Member
- Messages
- 73
This is only my second project welding
A few years ago I made some dog cages for my Freelander which turned out great. A friend recently bought a new van and asked me if I would/could make dog cages for that
The van is a 2011 Fiat Doblo...
My plans
The outer frame fabricated, squared and lower door hung...
The inner frame with doors hung... The offset upper doors are to accommodate her surf boards
Getting ready to hag the upper doors on the outer frame...
Lower centre divider fabricated and 1st dry fit...
Back from the powder coaters and fitting in the van
This rack was the hardest part to design as the last thing I wasted was two surf boards to decapitate the passenger then go through the windscreen
A few years ago I made some dog cages for my Freelander which turned out great. A friend recently bought a new van and asked me if I would/could make dog cages for that
The van is a 2011 Fiat Doblo...
My plans
The outer frame fabricated, squared and lower door hung...
The inner frame with doors hung... The offset upper doors are to accommodate her surf boards
Getting ready to hag the upper doors on the outer frame...
Lower centre divider fabricated and 1st dry fit...
Back from the powder coaters and fitting in the van
This rack was the hardest part to design as the last thing I wasted was two surf boards to decapitate the passenger then go through the windscreen