Hi, connected up my newly purchased Murex 161 Autolynx.
Wired fitted, new regulator, new helmet etc etc.
Welds really well (given my limited skills). Very pleased with myself and my welder.....
Turn off the power switch, big bang from machine....whooops!!!
Switch back on no noise!!
Remove side panel and spinning part of fans has detached itself ???
Replaced it, turned on - fans spins.
Turn off, fan slows, bang - detaches itself, then after refit will not spin??
Anybody else had this issue?
How much is a new fan?
Your thoughts please????
Wired fitted, new regulator, new helmet etc etc.
Welds really well (given my limited skills). Very pleased with myself and my welder.....
Turn off the power switch, big bang from machine....whooops!!!
Switch back on no noise!!
Remove side panel and spinning part of fans has detached itself ???
Replaced it, turned on - fans spins.
Turn off, fan slows, bang - detaches itself, then after refit will not spin??
Anybody else had this issue?
How much is a new fan?
Your thoughts please????