Welder Wilk
New Member
- Messages
- 13
- Location
- Lincoln UK
Good day fine people.
So the welder was running fine after replacing the resistor on top of the contactor but after about 3 days the welder stopped re acting to the trigger input, so i remover the side case and with a length of wooden dowel I started to move wires around for a break or loose connection.
After lots of messing about I found the if I just tapped the contactor it struck up as normal.
The label on the side says it is a
Klockner Moeller "DIL 00-52d "
Am I able to still purchase one of these in the UK, I can find them in the USA.
Any assistance with this would be good.
Many Thanks
So the welder was running fine after replacing the resistor on top of the contactor but after about 3 days the welder stopped re acting to the trigger input, so i remover the side case and with a length of wooden dowel I started to move wires around for a break or loose connection.
After lots of messing about I found the if I just tapped the contactor it struck up as normal.
The label on the side says it is a
Klockner Moeller "DIL 00-52d "
Am I able to still purchase one of these in the UK, I can find them in the USA.
Any assistance with this would be good.
Many Thanks