Steve.wain
Member
- Messages
- 5
I have a decent quality inverter welder and have a few small welds to do which would be better migged. Is it possible to get some sort of kit to convert my machine to do this? Or could I make a wire feed, buy a torch and go? Is there more to it than that? I've tried searching, but keep finding that my criteria can't be searched for, as the words are too short.
I did find some comments about mig being constant current and mma being constant voltage (or was it the other way round?
)
I could TIG them but can't get the gas easily, but fancied having a go at gasless MIG anyway. The job has to be done outside.
Any help appreciated.
I did find some comments about mig being constant current and mma being constant voltage (or was it the other way round?

I could TIG them but can't get the gas easily, but fancied having a go at gasless MIG anyway. The job has to be done outside.
Any help appreciated.