Mick Annick
Forum Supporter
- Messages
- 2,432
- Location
- Burgundy, France (450 miles SE of Somerset)
As the workshop refurbishment should be finished early next month I’ve starting think about equipment - I’ve put a bit aside for a new welder to replace the little Selco I’m using at the moment, and would welcome your advice as to which machine to go for.
Budget is £500, but will stretch to £600 if needed.
This should get me a Fronius Transpocket 150 or a Kemppi Minarc Eco 180, but is there anything better out there in this price range? I should consider GYS if only fore the service back-up over here.
Budget is £500, but will stretch to £600 if needed.
This should get me a Fronius Transpocket 150 or a Kemppi Minarc Eco 180, but is there anything better out there in this price range? I should consider GYS if only fore the service back-up over here.