milling vice but which one to choose?

[gaz1]

since getting both the myford 7 and milling machine old type horizontal mill ive been looking at milling machine vices

but i still cant decide which one to get and to be truthful ive been on the lines of a big vice instead of a small one

i know these dont look much good but to a degree was thinking could slot another made vice in there much smaller for smaller pieces

7" one


i cant see what you would use a swivel one for
im aware these are good


ive looked at home made ones

 

[addjunkie]

I have 4 but tend to use this most of the time, they all have their uses.
http://www.shobha-india.com/precision-machine-vises/precision-machine-vices-p11.html#1

suspect this is where the home made one is copied from

 

[brightspark]

u would use a swivel vice on the mill for anything that needs machining that isn't 90 decrees to the cutter or table and don't want to remove it so the operation can be machined in one go

 

[optima21]

Ive got 2 home made vices, but they will be lighter duty than most commercial ones.

the top one just clamps into the tee slots on the milling machine with tee nuts.