SBK
Member
- Messages
- 458
Hi all
After browsing the forum for some time in a quest for knowledge re which Tig
welder, I have just bought a Miller Dialarc HF-E 300.
My question is on the control panel there are blanked off plugs for pulse control,up slope,down slope etc,but inside there is no control board.
Is this something that can be added on the the unit?
Thanks for any help that you can give .
After browsing the forum for some time in a quest for knowledge re which Tig
welder, I have just bought a Miller Dialarc HF-E 300.
My question is on the control panel there are blanked off plugs for pulse control,up slope,down slope etc,but inside there is no control board.
Is this something that can be added on the the unit?
Thanks for any help that you can give .