Daniel Inabinett
New Member
- Messages
- 25
- Location
- United States
I was givin this mig welding machine from my Father and the gun was rigged and really was not useable. I bought a new mig gun hooked it up exactly how the other was. Side note: I have seen the machine work before I received it. My first thoughts were that the switch was bad so I checked the voltage on the other side and there was voltage. So my next thoughts were the relay buy it tested out good. I checked the voltage on the wires going to the coil on the relay and they were only putting out .03vdc.
I believe that it is the transformer on the PCB. I might be wrong. I am going to check the incoming voltage to the PCB tonight.
Am I going in the right direction with this?
Any help is greatly appreciated I need this thing up and running.
I believe that it is the transformer on the PCB. I might be wrong. I am going to check the incoming voltage to the PCB tonight.
Am I going in the right direction with this?
Any help is greatly appreciated I need this thing up and running.