Little Jerry
Member
- Messages
- 140
- Location
- Australia
Just curious as to opinions on the best fix for this gap (Its 1mm sheet metal on a truck bed) - should I cut a small patch piece or just clean up around the edges and fill it with the mig welder and a copper backer?
Apologies for the imperial measurements (I had planned on posting it on an American forum). For metric its 5mm x 50mm.
A 5mm hole I'd fill no problems but not sure if the width changes things at all?
Appreciate any assistance
Adam
Apologies for the imperial measurements (I had planned on posting it on an American forum). For metric its 5mm x 50mm.
A 5mm hole I'd fill no problems but not sure if the width changes things at all?
Appreciate any assistance
Adam