Mig Feed Roller

[Kelvinblacksmith]

I have a spare motor for a mig welder I don't know what Model of mig it came from ....( car boot junk box find cost £1 ) .... I need a 0.6 / 0.8 wheel for it ... the drive shaft has one flat edge and I can't find any on ebay etc with a three quarter round and flat edge ....It has a screw thread in the end for a retainer .... Has anyone seen this type and can let me know the Mig it fits .... Its from the smaller machine range I should think ... Regards Kelvin

 

[rtbcomp]

You may be able to get one with a round hole and a grub screw which you can tighten onto the flat.

 

[gordon stephenson]

If you can't find one, One could be made on a lathe very easily with grub screw acting on the flat portion as suggested above, and the retainer screw would not be required.