Omniata
Forum Supporter
- Messages
- 3,191
- Location
- UK
I need a metal dome forming...
Well, sounds easy but... Needs to be made out of approximately 12mm steel, it's to go on the end of a piece of pipe, 220mm external diameter, 12mm thick...
The dome has to drop on a radius to a 100mm diameter base...
Basically so it doesn't tip over...
The ends need chamfering to 45°, but I think I can manage that with "ol' grindy"
Can anybody on here make one, or advise a source???
I'd had a quote for a flat plate for peanuts but would prefer the dome...
As a clue it's to form the base for a crucible...
Final dimensions to be confirmed...
Well, sounds easy but... Needs to be made out of approximately 12mm steel, it's to go on the end of a piece of pipe, 220mm external diameter, 12mm thick...
The dome has to drop on a radius to a 100mm diameter base...
Basically so it doesn't tip over...
The ends need chamfering to 45°, but I think I can manage that with "ol' grindy"
Can anybody on here make one, or advise a source???
I'd had a quote for a flat plate for peanuts but would prefer the dome...
As a clue it's to form the base for a crucible...
Final dimensions to be confirmed...