cardiffrob
Member
- Messages
- 1,518
- Location
- Wales, Llantwit Major.
Morris Minors (again).
I was wondering how difficult it might be to get new floor skins 'pressed'? If the dimensions could be sorted, can they be formed? Would it need a MASSIVE press that would make the job way too expensive? The design, minus the sills, looks like a fairly simple flat design if the trans tunnel was left out of the plan. Currently there are 1/4 panels but they always seem to be short of the desired dimensions for a decent repair so a weld ends up about 2 inches short of the end of the rust. Grrrr.
I was wondering how difficult it might be to get new floor skins 'pressed'? If the dimensions could be sorted, can they be formed? Would it need a MASSIVE press that would make the job way too expensive? The design, minus the sills, looks like a fairly simple flat design if the trans tunnel was left out of the plan. Currently there are 1/4 panels but they always seem to be short of the desired dimensions for a decent repair so a weld ends up about 2 inches short of the end of the rust. Grrrr.