mag drill

[oilcooled :)]

will this chuck fit this drill can anyone tell me??

http://cgi.ebay.ie/Magnetic-Drill-C...Home_Garden_PowerTools_SM?hash=item48372b90a7

http://cgi.ebay.co.uk/EVOLUTION-POW...Home_Garden_PowerTools_SM?hash=item3efa1e0df5

Thanks

 

[Tino]

I'm reasonably sure it will fit, looks good.

 

[scarecrow]

it should fit all mag drills
but it only fits into the end of the mag so there wont be much clearance
usually you unscrew the shaft just under the motor and attach the chuck so that you will have enough clearance for chuck and drill-bit

 

[Tigman]

I dont think my Rotabroach would take a chuck and a 1/2" drill and still operate !

 

[wyn]

The arbor can be unscrewed from the drill along with the bottom support.
You can then fit an adaptor and chuck to the drill giving a lot more clearance for drill bits. More expensive though and a lot more grief to change from drills to cutters.

 

[Welderpaul]

Cut the drill bits

 

[Hitch]

They are handy if you've a big mag drill. saves keep changing stuff about, just put the chuck in the weldn holder.

For smaller ones, such as Rotabroach Puma you normally remove the shaft, cant remember how chuck fits on, think it might just a 1/2" unf that screws into the chuck directly...no adaptor required.

 

[agri-welding-services]

just bought a new adapter for mine if i seen that on ebay it would have saved me a pretty penny. But on the upside the new one is much stronger looking.