e5c0rt.mk1
Member
- Messages
- 168
- Location
- UK
Hi,
I've got a unibor eq100 mag drill. Bought it second hand about 3 years ago, and its been great till yesterday and today.
I was cutting a 100mm hole through 40mm plate, on its lowest speed setting, and it was going great till about 10mm of the end. It started to speed up for no reason for about 5 seconds then slows back down or it sometimes just stops completely.
Then cut a 45mm hole through some plate and it was doing it again, and doing another 100mm hole today it did it all the time.
Does anyone know what could be making it do this? It only does it when cutting a hole, if its not cutting it doesnt do it.
Thanks
I've got a unibor eq100 mag drill. Bought it second hand about 3 years ago, and its been great till yesterday and today.
I was cutting a 100mm hole through 40mm plate, on its lowest speed setting, and it was going great till about 10mm of the end. It started to speed up for no reason for about 5 seconds then slows back down or it sometimes just stops completely.
Then cut a 45mm hole through some plate and it was doing it again, and doing another 100mm hole today it did it all the time.
Does anyone know what could be making it do this? It only does it when cutting a hole, if its not cutting it doesnt do it.
Thanks