andy198712
Member
- Messages
- 31
- Location
- Cornwall
Hi,
I have a 135te welder and I’m welding 316 stainless pipe which I believe is 1.6mm
I brought stainless wire and still using normal welding gas mix.
I seem to find when I start the weld it sort of machine guns then after a second goes to a nicer clean bead....
still pretty rough, it seems a lot hard to weld then mild steel!? I was okay at that.
This is just making me look bad
it’s only for a personal exhaust. But didn’t want to use mild wire.
Is that symptom caused by wire feed too slow or ? Just strange it flows well after a second or two....?
cheers
Andy
I have a 135te welder and I’m welding 316 stainless pipe which I believe is 1.6mm
I brought stainless wire and still using normal welding gas mix.
I seem to find when I start the weld it sort of machine guns then after a second goes to a nicer clean bead....
still pretty rough, it seems a lot hard to weld then mild steel!? I was okay at that.
This is just making me look bad
it’s only for a personal exhaust. But didn’t want to use mild wire.
Is that symptom caused by wire feed too slow or ? Just strange it flows well after a second or two....?
cheers
Andy