Another question where the answer may be obvious to everyone except me..
I've just bought an MT3 ER32 collet holder for the lathe. It has M12 drawbar thread.
To get what I need done quickly - facing some short pieces - can I just use M12 threaded bar as the drawbar?
Longer term - would I just cut some M12 thread onto a piece of tube to allow longer rods through?
Thanks as always.
I've just bought an MT3 ER32 collet holder for the lathe. It has M12 drawbar thread.
To get what I need done quickly - facing some short pieces - can I just use M12 threaded bar as the drawbar?
Longer term - would I just cut some M12 thread onto a piece of tube to allow longer rods through?
Thanks as always.