Sorry, I do not know what you mean with the vat free, sharing and requestAgree with gaz, also the Clarke 135 would do you fine.
Machine Mart VAT free are often shared among the members so put a request up for one if you wish.
For a bit of extra budget the GYS Smartmig 162 is very popular.
Every now and again Machine Mart send out VAT free vouchers to previous customers, many of the members get them and if not wanting to use them pass them on to each other.Sorry, I do not know what you mean with the vat free, sharing and request
Wow £70 for a 151. That's unbelievably cheap.Well I've order a Clarke. 151en ,from Amazon for 70 pound cheaper than machine mart
It was £264…£70 cheaper then machine martWow £70 for a 151. That's unbelievably cheap.
Ha. I am a plonker.It was £264…£70 cheaper then machine mart
It was £264…£70 cheaper then machine mart
The one advertised is a non gas, the one I have ordered is a gas one, plus it is only the kids inheritance I am spending, so who cares LOLhttp://www.amazon.co.uk/Clarke-MIG151EN-240V-Turbo-Welder/product-reviews/B0036UN184
youve paid dearer than machine mart for the 151
https://www.machinemart.co.uk/p/mig...GS-010110151&gclid=CMOqsf6r2M0CFVXNGwodmKYHCg
£251.98 inc. VAT
infact 13.00 dearer then if you had got a no vat from the forums you would have been paying much less
£209.98 ex. VAT using Machine Mart VAT free vouchers
13.00 buys something else like extra tips or wire for the mig that your using
I'm going to take a shot of a friends new Clarke 135 using 5% CO2 / Argon mix this week.
If I buy one of the inductor welders around say £500 to £600 or so for the bare welder, I will get a better feed motor, probably a better torch and more refined voltage adjuster also the bare welder will be say half the weight of a transformer based welder.
Will the inductor based machine give a better weld or is it easier to use mainly on cars than the Clarke.
The GYS 162, I assume will be better built than the Clarke but will it be any easier to use than the Clakre, it will be a similar weight as it is transformer based. Will it be any easier or not to weld with this than with an inductor welder or will it be similar.