Looking for a couple of bits done on a lathe

[Sean]

Not sure of the protocol or where to post ...but.

need some bits run off in mild steel for some old car stuff.
1: rings, OD 24mm inside 12.5mm depth 8.5 to 9mm

2: hexs 16mm af centre hole 7.5mm depth 8.5

quantities depends on cost
anyone interested?
costs?

PM me
Thanks,
Sean

 

[graffian]

Hope you made a mistake on those sizes?
Your bit of paper said a 14mm hole in the round one..

I put them in the post this afternoon.
Did 19 of both, that's including a few that are not the right
size. I chucked in the ones I made while when I was getting
the size right and fooling around with the boring tool to make
the undercut.

 

[Sean]

your a star!

As for the sizes the sizes it was an emotional week that one we had to have the dog put down.
Thing is i cant for the life of me remember which was correct - hopeless