Snorty
New Member
- Messages
- 28
- Location
- West Lothian, Scotland
Guys, I’ve not had my speedtec 200c long and it has only been used a couple of times. I’m just learning with it. Today it seemed to be doing something a bit weird...the wire would feed normally for about 10 seconds then stop feeding and the gas would cut off. This was resulting in the wire sticking to the piece / burn back and basically everything going pear shaped. After the wire would stop, releasing the trigger and pulling again would start it again but it would do the same again. Just looking for any thoughts before I contact the supplier. I did take a wee video but I’m not sure if I can post it from the phone. I’ve added a pic of the current setup. Any help greatly appreciated!!