brokenbiker
Member
- Messages
- 10,437
- Location
- Llanbobyll, south wales
to be honest, if you wanted it perfect and the 19mm is infact a bearing fit then I would turn it down from 20mm mild steel, thread one end M16x 2.0 as per the drawing and the other end M20x2.5 or M18x2.00, a nut both ends would make life a lot easier if you ever (god forbid) binned it and damaged the nut end and were unable to remove one of the nuts. this would obviously call for M18 as it would give clearance for the shaft to come out though the bearings and/or sleeves/spacers