Label Holder

[ukracer]

I am looking to create a label holder to clip onto a bale crate.

I found one that is similar to what i need.

But this one has the clip on the end of the long part of the label holder.

I need to get one that follows the green line with the clip along the back. (if that makes sense)

Any suggestions as to what operations would be best?

 

[indykid]

How many do you need? That would probably be the biggest factor driving your options

 

[Erie Fred]

Maybe something in here ?

Challenge Validation

 

[ukracer]

How many do you need? That would probably be the biggest factor driving your options

Perhaps ihave not been clear enough.
I want quite a few so i want to design one in fision 360.
But I dont have a clue on where to start.

 

[Misterg]

i want to design one in fision 360.
But I dont have a clue on where to start.

I would draw the silhouette viewed from the side (so clip and frame);
Extrude to the required width;
Hollow out the recess for the label;
Add fillets and chamfers to taste.

 

[BrokenBiker]

In the sketch before the extrusion, inside the clip where the clip meets the body there is a 90 sharp join that I would radius a bit to prevent it being a failure point.
Only because I've had that exact problem with 3d prints myself and it's frustrating to have it happen then realise it only needed a small radius to prevent it